ODE Gas solenoid valve 1/2" 230 AC 20kPa IP65

  • new
$408.90
Availability:
In stock
SKU
MD21G04C4B015
ODE Gas solenoid valve 1/2" 230 AC 20kPa IP65
ODE Gas solenoid valve 1/2" 230 AC 20kPa IP65 ODE Gas solenoid valve 1/2" 230 AC 20kPa IP65 ODE Gas solenoid valve 1/2" 230 AC 20kPa IP65

1/2" BSPT inlet and outlet, 230v AC, 20kPa solenoid valve

Normally closed solenoid valves for automatic normally closed gas with fast opening. They open the flow of gas when the coil is
electrically powered and close them when power is disconnected. They can be controlled by pressure switches, thermostats, etc.
They can be equipped with CPI switches to control the valve’s obturator position (closed) remotely. The CPI can also be
installed at a later time ONLY IF the device is set-up properly (cap under the valve body). Further information regarding the
CPI switch is available in 6.0.
Reference standards: EN 161 - EN 13611.

Use : non-aggressive gases of the three families (dry gases)
• Ambient temperature : -20 ÷ +60 °C
• Supply voltages (see table 2) : 12 Vdc - 12 V/50 Hz - 24 Vdc - 24 V/50 Hz - 110 V/50-60 Hz - 230 V/50-60 Hz*
• Power supply tolerance : -15% ... +10%
• Electric wiring : cable gland M20x1.5
• No. cycles/hour : see table 2a - 2b - 2c
• Absorbed power : see table 2a - 2b - 2c
• Maximum operating pressure : MD21... 200 mbar
MD22... 360 mbar
• Opening time : <1 s
• Closing time : <1 s
• Protection rating : IP65
• Class : A
• Mechanical resistance : Group 2
• Rp Threaded connections : (1/2” DN 15 - 3/4” DN 20 - 1” DN25 - 1 1/4” DN 32 - 1 1/2” DN 40 - 2” DN 50)
according to EN 10226

Filter element : 1 mm wire mesh
• In compliance with : Regulation (EU) 2016/426 (Appliances burning gaseous fuels)
Directive EMC 2014/30/EU - Directive LVD 2014/35/EU
Directive RoHS II 2011/65/EU
* Only single-phase, the device does not work if powered with three-phase voltage

-For more information. inquire about booklet. 

Write Your Own Review
You're reviewing:ODE Gas solenoid valve 1/2" 230 AC 20kPa IP65
Your Rating